Reported Concern: Washer in Sector 78 stopped with F02 drain alarm and water trapped inside drum.
Technician Inspection: Lower coin trap filter was choked with lint, threads, and hairpins from laundry.
Repair Work Completed: Flushed lower drain chamber, cleared pump impeller, and confirmed smooth discharge.
Parts: ₹0 (Filter Cleaning)
•
Labour: ₹400 (Drain Servicing)
•
Total Estimate: ₹400
F02 error cleared; water drained completely in 80 seconds.
Reported Concern: Washing machine in Sector 62 flat showed zero display lights after an evening voltage spike.
Technician Inspection: Primary surge fuse and varistor on the controller PCB had blown to protect the main processor.
Repair Work Completed: Fitted replacement surge protection components and checked main power board tracks.
Parts: ₹280 (Protection Components)
•
Labour: ₹600 (PCB Servicing)
•
Total Estimate: ₹880
Display lit up normally and self-diagnostic routine passed with zero errors.
Reported Concern: Washer in Sector 137 shook violently during spin cycle, making a loud knocking sound.
Technician Inspection: Agitator drive teeth had stripped and suspension damper springs had weakened.
Repair Work Completed: Fitted replacement suspension damper rods and a fresh agitator drive spline insert.
Parts: ₹850 (Damper Rods & Spline)
•
Labour: ₹450 (Fitting & Balance Tuning)
•
Total Estimate: ₹1,300
Washer completed spin cycle smoothly without cabinet shaking.
Reported Concern: Water continuously trickled into drum in Sector 50 flat even when machine power was turned off.
Technician Inspection: Fine dirt sediment had wedged open internal rubber seal of double water inlet valve.
Repair Work Completed: Fitted a replacement double-coil cold water inlet valve and added clean mesh filter.
Parts: ₹650 (Inlet Solenoid Valve)
•
Labour: ₹350 (Replacement & Leak Test)
•
Total Estimate: ₹1,000
Water supply cut off cleanly at designated water level.
Reported Concern: Wash tub in Sector 120 worked normally, but spin tub hummed quietly without turning clothes.
Technician Inspection: Spin motor start capacitor had weakened to 1.8µF and safety lid brake cable had stuck.
Repair Work Completed: Freed brake mechanism and fitted a replacement 5µF motor run capacitor.
Parts: ₹250 (Motor Capacitor)
•
Labour: ₹350 (Brake Servicing)
•
Total Estimate: ₹600
Dryer tub accelerated immediately to full spin speed.
Reported Concern: Door closed firmly in Sector 93, but washer beeped and refused to start program.
Technician Inspection: Door latch microswitch contact had oxidised and failed to signal closed circuit.
Repair Work Completed: Cleaned microswitch terminals, adjusted latch alignment, and tested safety interlock.
Parts: ₹0 (Cleaning & Alignment)
•
Labour: ₹350 (Door Servicing)
•
Total Estimate: ₹350
Door locked properly and wash cycle started immediately.