Reported Concern: Front load washer in Sector 78 stopped with 5C drain error and water pooled inside drum.
Technician Inspection: Lower debris filter was choked with lint and a small plastic token from pockets.
Repair Work Completed: Flushed lower drain chamber, cleared pump impeller, and confirmed smooth discharge.
Parts: ₹0 (Filter Cleaning)
•
Labour: ₹400 (Drain Servicing)
•
Total Estimate: ₹400
5C error cleared; water drained completely in 75 seconds.
Reported Concern: Washing machine in Sector 62 flat showed zero display lights after an evening voltage spike.
Technician Inspection: Ceramic fuse and varistor on the Digital Inverter PCB had blown to protect the main processor.
Repair Work Completed: Fitted replacement surge protection components and checked main power board tracks.
Parts: ₹280 (Protection Components)
•
Labour: ₹600 (PCB Servicing)
•
Total Estimate: ₹880
Display lit up normally and self-diagnostic routine passed with zero errors.
Reported Concern: Washer in Sector 137 shook violently and displayed Ub error during spin cycle.
Technician Inspection: Hydraulic suspension springs had weakened and clothes balled tightly on one side.
Repair Work Completed: Fitted replacement suspension damper rods and calibrated dynamic tub levelling.
Parts: ₹800 (Set of Damper Rods)
•
Labour: ₹450 (Fitting & Balance Tuning)
•
Total Estimate: ₹1,250
Washer completed 1000 RPM spin smoothly without throwing Ub unbalanced error.
Reported Concern: Water filled very slowly in Sector 50, causing washer to pause with 4C error alert.
Technician Inspection: Hard water sediment had blocked the mesh filter on the double water inlet valve.
Repair Work Completed: Cleaned inlet filter mesh and replaced stiffened cold inlet solenoid valve.
Parts: ₹600 (Double Inlet Valve)
•
Labour: ₹350 (Replacement & Leak Test)
•
Total Estimate: ₹950
Drum filled to normal mark in under 3 minutes; 4C error resolved.
Reported Concern: Display showed dDC error in Sector 120 and refused to start program even with door closed.
Technician Inspection: Microswitch contact on the smaller AddWash door flap had developed oxidised contacts.
Repair Work Completed: Cleaned microswitch terminals, aligned door latch hook, and reset control board.
Parts: ₹0 (Contact Cleaning & Alignment)
•
Labour: ₹400 (Door Servicing)
•
Total Estimate: ₹400
dDC error cleared; wash cycle started immediately upon pressing Start.
Reported Concern: Water leaked onto utility floor in Sector 93 during heavy wash load.
Technician Inspection: Small tear found in the bottom fold of the front rubber door gasket.
Repair Work Completed: Installed a model-compatible front door boot gasket with tension clamp spring.
Parts: ₹1,150 (Door Boot Gasket)
•
Labour: ₹450 (Panel Disassembly & Fitting)
•
Total Estimate: ₹1,600
Door sealed completely watertight with zero leaks.