Reported Concern: Front load washer in Sector 78 stopped mid-cycle with E18 drain timeout error and water trapped inside drum.
Technician Inspection: Technician opened lower service flap; lint, coins, and threads had jammed the magnetic drain pump impeller.
Repair Work Completed: Cleared lower coin trap filter, inspected emergency drain hose, and tested pump spin under load.
Parts: ₹0 (Drain Filter Cleaning)
•
Labour: ₹400 (Drain Servicing)
•
Total Estimate: ₹400
Error E18 cleared; drum drained water within 80 seconds and finished high-speed spin.
Reported Concern: Washer in Sector 62 high-rise went dead after a sudden evening thunderstorm voltage surge.
Technician Inspection: Primary surge fuse on the EcoSilence inverter drive module had blown cleanly, shielding the main motor.
Repair Work Completed: Installed a new ceramic surge fuse on the board and checked wall socket earthing resistance.
Parts: ₹280 (Protection Components)
•
Labour: ₹600 (Module Servicing)
•
Total Estimate: ₹880
Display panel powered back on and test wash cycle completed without errors.
Reported Concern: Washer in Sector 137 shook heavily across the utility balcony floor during 1200 RPM spin.
Technician Inspection: Both friction damper struts had lost hydraulic resistance, causing drum balance to wobble.
Repair Work Completed: Fitted a matched pair of genuine Bosch-compatible suspension dampers and levelled rubber feet.
Parts: ₹850 (Pair of Dampers)
•
Labour: ₹450 (Fitting & Levelling)
•
Total Estimate: ₹1,300
Drum spun smoothly at maximum speed without cabinet shaking.
Reported Concern: Display showed E17 alert in Sector 50 flat as water trickled very slowly into the detergent drawer.
Technician Inspection: Sediment had clogged the double mesh screen inside the cold water inlet solenoid valve.
Repair Work Completed: Cleaned intake filter mesh, cleared internal valve plunger, and verified 2.5 bar water inflow.
Parts: ₹0 (Filter Cleaning & Tuning)
•
Labour: ₹350 (Inlet Servicing)
•
Total Estimate: ₹350
Water filled to correct level within 3 minutes; wash program began automatically.
Reported Concern: Machine sounded continuous beep alarm with E23 code in Sector 120, running drain pump non-stop.
Technician Inspection: Small pinhole in internal recirculating hose had dripped water into bottom tray, lifting safety float switch.
Repair Work Completed: Replaced flexible rubber hose, dried bottom base tray, and reset Aquastop float switch.
Parts: ₹350 (Reinforced Hose)
•
Labour: ₹550 (Tray Dismantling & Reset)
•
Total Estimate: ₹900
Aquastop alarm cleared completely and machine resumed normal wash cycles.
Reported Concern: Water trickled from beneath the door glass in Sector 93 during heavy rinse cycles.
Technician Inspection: Clothing zipper had torn a small flap in the lower rubber door seal bellows.
Repair Work Completed: Installed a model-matched rubber door gasket and tightened circular spring clamp firmly.
Parts: ₹1,250 (Moulded Door Boot Gasket)
•
Labour: ₹450 (Front Panel Dismantling)
•
Total Estimate: ₹1,700
Door sealed 100% watertight with zero water drops on floor.