Reported Concern: Cooktop burner in Sector 62 produced a weak yellow flame that blackened cooking pots.
Technician Inspection: Spilled milk and oil had dried into hard carbon inside the tiny gas holes of the brass burner.
Repair Work Completed: Cleaned burner holes with safe chemical solution and cleared primary gas air intake.
Parts: ₹0 (Burner Hole Cleaning)
•
Labour: ₹350 (Burner Servicing)
•
Total Estimate: ₹350
Flame restored to sharp blue cone with full cooking heat.
Reported Concern: Control knob on built-in glass hob in Sector 78 became extremely stiff and hard to turn.
Technician Inspection: Cooking grease had entered the internal brass valve cone taper spindle.
Repair Work Completed: Dismantled valve assembly, cleaned hardened grease with solvent, and applied gas valve grease.
Parts: ₹0 (Valve Degreasing & Lubrication)
•
Labour: ₹400 (Hob Servicing)
•
Total Estimate: ₹400
Gas knob rotated effortlessly with smooth, precise flame adjustment from high to low.
Reported Concern: Automatic spark igniter in Sector 137 clicked non-stop without touching knob after wet cleaning cooktop.
Technician Inspection: Moisture had entered the microswitch collar underneath the knob shaft, triggering the sparker.
Repair Work Completed: Dismantled glass hob fascia, dried microswitches with warm air, and fitted silicone water seals.
Parts: ₹120 (Silicone Shaft O-Rings)
•
Labour: ₹380 (Ignition Circuit Servicing)
•
Total Estimate: ₹500
Spark clicks only when knob is pushed down deliberately; stops immediately on release.
Reported Concern: Burner lit with lighter in Sector 50, but went out as soon as knob was released after 10 seconds.
Technician Inspection: Safety sensor tip was coated with cooking oil soot, failing to detect flame heat.
Repair Work Completed: Cleaned sensor probe tip with fine abrasive and tested safety magnetic valve.
Parts: ₹0 (Safety Sensor Cleaning)
•
Labour: ₹350 (Safety System Check)
•
Total Estimate: ₹350
Flame stays lit within 3 seconds of knob press; automatically cuts gas if flame blows out.
Reported Concern: Customer moved into Sector 120 flat and needed cooktop converted from cylinder LPG to pipeline PNG.
Technician Inspection: LPG nozzles were 0.65mm, which produced tiny flickering flames on lower pressure piped PNG gas.
Repair Work Completed: Fitted PNG-calibrated 1.1mm brass injector nozzles across all three burners and adjusted air shutters.
Parts: ₹300 (Set of 3 PNG Brass Jets)
•
Labour: ₹400 (Conversion & Leak Testing)
•
Total Estimate: ₹700
All burners produced clean blue flames optimized for piped natural gas.
Reported Concern: Heavy cooking pan wobbled on Sector 93 cooktop and liquid seeped into counter cut-out.
Technician Inspection: Pan support rubber pads had worn out and perimeter counter sealing foam had degraded.
Repair Work Completed: Installed heat-resistant silicone pan feet and resealed glass hob perimeter with waterproof bead.
Parts: ₹180 (Heat Resistant Grommets)
•
Labour: ₹320 (Hob Levelling & Sealing)
•
Total Estimate: ₹500
Cookware rested solid on stove; perimeter sealed 100% against liquid spills.